Content-based Wake-up for Top-k Query in Wireless Sensor Networks

Any wake-up request, setting the Pwon flag or a LOW-to-HIGH transition on STB_N will clear UVNOM and the timers, allowing the voltage regulators ...







ATA6570 Data Sheet - Microchip Technology
Wake up flag for Remote Wake up pattern. Bit is latched until a read and clear access. 2. WUF. Wake up flag for Remote Wake up Frame. Bit is ...
NCA1145-Q1 - Datasheet (EN)1.0
This study depicts the project of a Wake-up Radio system for a Sensor. Network to operate in a frequency of 900 MHz with an OOK modulation, seeking ultra-low ...
TJA1443 | NXP Semiconductors
Target wakeup time (TWT) is a power-saving mechanism that. ? allows an AP to schedule specific times for devices or stations (STAs) to wake up and communicate.
NCV8518A - 250 mA LDO Linear Voltage Regulator with Watchdog ...
Abstract?Wake-up Receivers (WuRs) represent one of the most promising solutions for allowing an ultra low power con- sumption in wireless sensor networks.
TJA1043 High-speed CAN transceiver - Farnell
It provides parallel and remote wakeup for all nodes even in a point-to- point network as well as full support of partial networking. The overall wakeup ...
L99PM72GXP - STMicroelectronics
When the received address corresponds to the destination node, the ULP-MCU generates an interrupt to wake up the main node. The novel technique ...
Design of a Wake-up Radio for a Sensor Network
In the past years a new technology called Wake-Up Receivers. (WURs) has been proposed in the literature that promises ultra-low power communication without the ...
Target Wake Time - Cisco
The TLE6251D allows very low quiescent currents in stand-by mode while the device is still able to wake-up by a bus signal on the CAN bus. Based on the very low ...
Enhancing Wake-Up Receivers Reliability Through ... - l'IRISA
Any enabled wake-up or interrupt event (except SPIF), or an SPI command (provided a valid VIO voltage is connected), will wake up the transceiver from Sleep ...
A Self-Propagating Wakeup Mechanism for Point-to-Point Networks ...
smartphone, that can classify a wake-up alarm from other types of alarms. ... Many people use the smartphone to set up an alarm, such as a wake-up alarm, an alarm ...
Energy Efficient Communication using Wake-Up Receivers
The LTC®2956 is a micropower, wide input voltage range, configurable wake-up timer with pushbutton control. It periodically wakes up and turns on a ...
TLE6251D - Infineon Technologies
Dominant pulses with a length between tBUS (min) and tBUS (max) may lead to a wake-up. ... td(TXD-BUSon). Delay TXD to bus active. Driver tPLH td(TXD-BUSoff).